Setting up Olarm REMOTE CONNECT

Setting up Olarm REMOTE CONNECT

Olarm Remote Connect is a tool that allows you to use your Upload & Download (UDL) software remotely.

Alert
Note:
  1. Works on Windows PC/Laptops only
  2. Is the replacement of Olarm's "DeddyWare" software
  3. Version 2.02 or higher is required to support UDL through Olarm MAX & Olarm PRO
    1. The older DeddyWare software only supports UDL via Olarm PRO

1. Install Olarm REMOTE CONNECT by downloading the latest version below:

Olarm REMOTE CONNECT Software

  1. Once downloaded, double click on the Olarm REMOTE CONNECT file
    1. You may need to allow the file access to make changes to the PC

  1. Click "install" and allow the software to run

  1. Once installed, Olarm REMOTE CONNECT  will open automatically, and the following screen will open:


2.  To remotely connect to the supported alarm system, you will need to connect to the Olarm device first.
  1. Open your Olarm COMMAND CENTRE and navigate to the device you wish to connect to.
  2. Select the "Remote Programming" tab on the left-side and click Generate
  3. Copy the code that was generated.

4. Return to the Olarm REMOTE CONNECT screen
  1. Paste the code that was generated in COMMAND CENTRE
  2. Click on "Connect" to start the virtual session

5. Open the respective alarm systems supported Upload & Download (UDL) software
  1. Click here to see the guide for Olarm REMOTE CONNECT and BabyWare (Paradox)
  2. Click here to see the guide for Olarm REMOTE CONNECT and WinTex (Texecom)
  3. Click here to see the guide for Olarm REMOTE CONNECT and IDSwift (IDS)
Info
Note: You will need to download the alarm system's respective UDL software from the manufacture's website