Troubleshooting an Olarm MAX installation on Paradox MG/SP Alarm Systems
Olarm MAX shows a solid red LED after connecting to the alarm panel
If the Olarm device displays a solid red LED:
PC ID and password check: Ensure that the PC ID and password are set to 1234 or 0000.
Navigate to:
Related Articles
Installation of an Olarm MAX on Paradox MG/SP + Plus Alarm Systems
Installation Requirements Should the Alarm System Master Code be set to '1234', you'll need to change it. The default Master Code in the Olarm APP is also '1234', it must be updated to something different to ensure it doesn't match the default app ...
Installation of an Olarm MAX on Paradox MG/SP Alarm Systems
Installation Requirements Ensure that locations 910 & 911 (PC ID and Password) are set to the default values of 1234 or 0000. In most cases, these settings should already be configured correctly unless they were previously modified by an installer. ...
Troubleshooting an Olarm MAX installation on Paradox MG/SP + Plus Alarm Systems
Firmware version compatibility Paradox Plus panels running firmware versions below 1.1 are not compatible with Olarm MAX. To check the firmware version: Navigate to Location 980 on the alarm panel. If the version is below 1.1, update the panel ...
Olarm MAX Firmware Release Notes
This article summarises the changes for each firmware release for the Olarm MAX. In order to update the Firmware on your Olarm MAX, as a Primary user, please navigate to Device Setup then to the Firmware update tab in the Olarm APP. V1.8.0 Release ...
Installation of an Olarm MAX on Honeywell Galaxy 2 (G2) Alarm Systems
Installation Requirements An Olarm MAX G is required for this installation. If the Honeywell Galaxy 2 alarm system has an existing Ethernet Module & 3 Keypads, these must be removed before installing the Olarm MAX, as it will take their place. Step ...