Troubleshooting an Olarm MAX installation on Orisec Alarm Systems
Countdown not displaying in the Olarm APP when arming
If the countdown does not appear in the app during arming:
Firmware version check: This issue may occur if the panel is running a firmware version below V6.05.
To resolve:
Related Articles
Installation of an Olarm MAX on Honeywell Galaxy 2 (G2) Alarm Systems
Installation Requirements An Olarm MAX G is required for this installation. If the Honeywell Galaxy 2 alarm system has an existing Ethernet Module & 3 Keypads, these must be removed before installing the Olarm MAX, as it will take their place. Step ...
Installation of an Olarm MAX on Honeywell Galaxy Dimension Alarm Systems
Installation Requirements An Olarm MAX G is required for this installation. If the Honeywell Galaxy Dimension system has an existing Ethernet Module, this must be removed before installing the Olarm MAX, as it will take its place. Step 1: Connect the ...
Installation of an Olarm MAX on Orisec Alarm Systems
Installation Requirements Installing an Olarm MAX on an Orisec Alarm System requires an Olarm Orisec Adapter Board. Step 1: Programme your Orisec Alarm System Enter the Engineers code (default ‘1234’) & Press the Tick key Press the Down Arrow key ...
Using the Olarm MAX and its I/O ports as a communicator-only device
The Olarm MAX can function as a dedicated communicator for monitoring legacy alarm, fire, or panic systems that aren't directly supported. To set this up: Leave the yellow and green communication wires disconnected Power up your Olarm MAX device Add ...
Olarm MAX Firmware Release Notes
This article summarises the changes for each firmware release for the Olarm MAX. In order to update the Firmware on your Olarm MAX, as a Primary user, please navigate to Device Setup then to the Firmware update tab in the Olarm APP. V1.8.0 Release ...