TP Link/Tapo camera setup for Olarm MAX video

Requirements for Video on Olarm MAX

1. The Olarm MAX and your camera setup need to be on the same Wi-Fi network
   
2. The Olarm MAX won’t stream video using it’s cellular connectivity
   
3. The Olarm MAX requires a good quality Wi-Fi strength to stream cameras
   
4. The Olarm MAX needs to be on firmware version V.1.5.1 or later to support video
   
5. Your camera setup requires an adjustable substream
   
6. Ensure you camera setup has a static IP Address
   
7. Playback will only work should your DVR/NVR support it

Please note: this guide is specific to using the Tapo C200 but should be applicable to other similar cameras in the range.

Step 1: Download and setup your camera app as per manufacturer instructions

Step 2: Navigate to "camera" on the Tapo app

Step 3: Select "Settings/Advanced settings"

1. Setup a camera account
   
2. Select "Create new"
   
3. "Agree" to terms and conditions
   
4. Add a "username" and "password"
   
1. Required for the Olarm APP

Step 4: Select "Advanced settings/Network setup"

1. "Enable" the static IP
   
2. Take note of the "IP address"
   
1. Required for the Olarm APP
3. "Save" the settings
   

Step 5: Add the TP Link/Tapo camera to the Olarm APP

Follow the steps below to add the camera in the Olarm APP:

1. Open the Olarm APP
2. Navigate to the Olarm APP menu
   
3. Select "Device setup"
   
4. Tap on "Linked Cameras"
   
5. Select "Add Camera"
   
1. Name the camera
   
2. Enter the IP Address
   
3. Enter 554 for the "Port" (standard RTSP Port number)
   
4. Enter the following Live stream path/URL:
   
1. /stream2
   
5. Enter the "username" & "password" created in the Tapo App
6. Select "Test Connection"
   
7. "Save" the new camera

• Related Articles

• Olarm MAX Firmware Release Notes

  This article summarises the changes for each firmware release for the Olarm MAX. In order to update the Firmware on your Olarm MAX, as a Primary user, please navigate to Device Setup then to the Firmware update tab in the Olarm APP. V1.6.3 Release ...

• Using the Olarm MAX and its I/O ports as a communicator-only device

  The Olarm MAX can function as a dedicated communicator for monitoring legacy alarm, fire, or panic systems that aren't directly supported. To set this up: Leave the yellow and green communication wires disconnected Power up your Olarm MAX device Add ...

• How to update an Olarm MAX's firmware without connecting to a panel

  You can update your Olarm MAX firmware in two ways: Power up the device without connecting it to an alarm system or energizer If already connected to a system, simply disconnect the communication wires Once powered, the device will connect to the ...

• Setting up a Hikvision IP camera for Olarm MAX Video

  Requirements for Video on Olarm MAX The Olarm MAX requires strong or good Wi-Fi signal to stream cameras The Olarm MAX and your camera setup need to be on the same Wi-Fi network Please ensure the Wi-Fi network has 2.4Ghz enabled The Olarm MAX won’t ...

• Setting up a Hikvision NVR camera for Olarm MAX Video

  Requirements for Video on Olarm MAX The Olarm MAX requires strong or good Wi-Fi signal to stream cameras The Olarm MAX and your camera setup need to be on the same Wi-Fi network Please ensure the Wi-Fi network has 2.4Ghz enabled The Olarm MAX won’t ...