Pulling Area/Zone labels from the alarm system

Pulling Area/Zone labels from the alarm system

You can retrieve your alarm panel’s programmed zone labels directly into the Olarm APP for quick setup and accurate zone naming. This function is available only for supported alarm panel models.

  • Paradox

  • Texecom (Elite only)

  • Orisec

  • Honeywell

Notes
If your alarm system brand is not listed, manual editing of zone labels will be required.

  • Tap the menu icon (≡) in the top-right corner

  • Select Device Setup

  • Select Fetch Labels from Panel

  • Tap Agree to confirm the label fetch process

Notes
The Olarm APP will now retrieve and update zone labels based on your alarm panel’s programmed settings.

    • Related Articles

    • How to change Area/Zone labels in the Olarm APP?

      Only the Primary User can update Zone Labels in the Olarm APP. Customising zone names helps you easily identify different areas of your property. Tap the menu icon (≡) in the top-right corner Select Device Setup Select Areas/Zones Tap the edit icon ...

    • Why a zone would not be bypassing in the Olarm APP

      If the Olarm APP is not bypassing a zone, it could be caused by either the alarm system settings or a problem with the detector in that zone. Bypassing allows you to exclude a zone from triggering alarms when the system is armed, so if it fails, the ...

    • What are active or open zones in the Olarm APP

      In the Olarm APP, each zone of your alarm system is represented by a zone card. These zone cards provide a quick visual indication of the status of that zone, making it easier to see whether there has been any activity. A zone can either be closed ...

    • Can’t arm/disarm your alarm system in the Olarm APP

      If you are unable to arm/disarm your alarm system via the Olarm APP, follow the steps below to troubleshoot the issue. Check the Area/Partition Status In the Olarm APP home screen, confirm that the area/partition shows Disarmed. If the partition ...

    • Olarm APP is Stay arming instead of Arming

      If you try to Full Arm your alarm system but it goes into Part-Arm (Stay Arm) instead, it may be due to a panel setting that changes the arming mode based on whether the system thinks you are still inside the premises. This setting is usually off by ...