Installation of an Olarm MAX on Nemtek Energizers

Installation of an Olarm MAX on Nemtek Energizers

Installation Requirements

  • The Olarm MAX takes the place of one of the existing keypads. You will need to remove one of the keypads

Step 1: Power down

Before connecting the Olarm MAX, ensure that you power down the energizer.

Step 2: Connect the Olarm MAX

Cut and strip the 4-pin side of the reversible peripheral cable. Wire this end of the stripped peripheral cable into the terminals found on the back of the Olarm MAX.

  • Red to + (Positive)

  • Black to GND

  • Yellow to SERIAL 1

  • Yellow to SERIAL 1

    Cut and strip the 5-pin side of the cable and wire this stripped end of the cable into the energizer’s keypad terminals.

  • Red to + (Positive)

  • Black to - (Negative)

  • Green to DAT

  • Yellow not used (cut off the extra wire)


Open w3yQWHLet079sLeF6yAgKJKhTTY.avif

Step 3: Enter the Master Keypad Code in the Olarm APP

Once you have connected the Olarm MAX to your Nemtek energizer, and have added it to the Olarm APP. You will be prompted to enter the Master Code in the app. All Nemtek Energisers require the Master Keypad Code in the app for full app functionality.