LED States of the Olarm MAX

LED States of the Olarm MAX

LED States of the Olarm MAX

The Olarm MAX uses LED indicators to display its status and connectivity. Below is a guide to understanding what each LED state means.

Standard Operating States

Solid White – Booting up or powering on.

Flashing Green – Searching for the system to connect to.

Solid Blue – Successfully connected to the system and Olarm Cloud.

Connectivity Issue States

Two Blue Flashes – Connected to the cloud via cellular, but lost Wi-Fi connection.

Three Blue Flashes – Connected to the cloud via Wi-Fi, but lost cellular connection.

Orange – Connected to the system but unable to connect to the Olarm Cloud.

Red – Connected to the Olarm Cloud but unable to find the system.

Orange & Red Switching – Cannot connect to the Olarm Cloud or the system.

Firmware Update States

Purple & Blue – Updating firmware while connected to the system and cloud.

Purple & Green – Updating firmware while searching for the system.

Purple & Red – Updating firmware but unable to find the system.

By understanding these LED indicators, you can quickly diagnose and resolve connectivity or system issues with your Olarm MAX.

    • Related Articles

    • Troubleshooting Olarm MAX LED States

      If your Olarm MAX is displaying a specific LED state, use the following troubleshooting steps to resolve connectivity and system issues. Connectivity/Connection Issue States Two Blue Flashes – Connected to the cloud via cellular but lost Wi-Fi ...

    • How to update an Olarm MAX's firmware without connecting to a panel

      You can update your Olarm MAX firmware in two ways: Power up the device without connecting it to an alarm system or energizer If already connected to a system, simply disconnect the communication wires Once powered, the device will connect to the ...

    • Using the Olarm MAX and its I/O ports as a communicator-only device

      The Olarm MAX can function as a dedicated communicator for monitoring legacy alarm, fire, or panic systems that aren't directly supported. To set this up: Leave the yellow and green communication wires disconnected Power up your Olarm MAX device Add ...

    • Olarm MAX Firmware Release Notes

      This article summarises the changes for each firmware release for the Olarm MAX. In order to update the Firmware on your Olarm MAX, as a Primary user, please navigate to Device Setup then to the Firmware update tab in the Olarm APP. V1.6.5 Release ...

    • Installation of an Olarm MAX on Honeywell Galaxy Dimension Alarm Systems

      Installation Requirements An Olarm MAX G is required for this installation. If the Honeywell Galaxy Dimension system has an existing Ethernet Module, this must be removed before installing the Olarm MAX, as it will take its place. Step 1: Connect the ...