Step 1: Programme your Texecom Premier Alarm System

• Enter Engineering code

• Press the Programming Menu key

• Press [9] to enter the Programming Menu

• Enter [7] [6] to navigate to the Download Menu

• Press [2] to navigate to the UDL Passcode

• Enter [1 2 3 4] & Press the [Tick] or [Yes] key

• Press [8] to navigate to the ComIP-3 Subnet Mask

• Enter [0 0 8] (008 = 255.255.255.0 a full list of available values can be found in INS159-11 or later)

• Press [7] to navigate to the ComIP-2 Gateway IP Address

• Enter the following Gateway Address [1921 6800 0001]

• Press [6] to navigate to the ComIP-1 IP Address & Port

• Enter the following IP address and port number 1921 6800 0001 10001

• Press [5] to select the Com1 Device type

• Enter [3] to set the Device type to ComIP

• Press Programming Menu key

• Enter [9 9] to exit to programming

Note: If Com1 is in use, configure Com2 by entering [9] instead of [5] for Com2 device type followed by entering [3]. This step is to be done after the IP address and port number has been entered.

Step 2: Connect the Olarm MAX

Before connecting the Olarm MAX, power down your alarm system.

Plug the 5-pin side of the reversible peripheral cable to the programmed Com Port on your Texecom Premier Alarm System.

Cut and strip the 4-pin side of the cable. Wire this end of the cable into the terminals found on the back of the Olarm MAX.

• Red to + (Positive)

• Black to GND

• Yellow to SERIAL 1

• Green to SERIAL 2