You can connect your Olarm device to a local Wi-Fi network using the WPS method. This process allows for quick, password-free setup using your router’s WPS button.

Requirements

• Access to the back of your Olarm device

• A local Wi-Fi network within range

• A router with a WPS button
  

Step 1: Activate WPS pairing on the Olarm device

• Locate the Fn button on the back of your Olarm device.

• Press and hold the Fn button.

• Continue holding until the device flashes yellow (approximately 5 seconds).

• Release the button – your Olarm device is now in pairing mode and ready to connect.
  
  

Step 2: Activate WPS on your Wi-Fi router

• Press the WPS button on your Wi-Fi router immediately after starting the Olarm’s pairing process.

• The Olarm device will attempt to connect to your Wi-Fi network.

WPS activation steps may vary by router. Consult your ISP or router manual if unsure.

Step 3: Confirm Successful Connection

Once connected, your Olarm device will either:

• Flash blue

• Or show a solid blue light

This confirms a successful Wi-Fi connection.

Extra Tips

• Keep the Olarm device within range of the router during setup.

• If pairing fails, restart the router and repeat the steps.

• Some routers may require WPS to be enabled via router settings before pressing the physical button.